Automatically Setting The Printer's Ip Address; Dynamic Methods Of Setting The Printer's Ip Address - Xerox Phaser 6360 User Manual

Automatically Setting the Printer's IP Address

If the printer is connected to a small established TCP/IP network without a DHCP server, use
the installer on the Software and Documentation CD-ROM to detect or assign an IP address to
your printer. For further instructions, insert the Software and Documentation CD-ROM into
your computer's CD-ROM drive. After the Xerox Installer launches, follow the prompts for
installation.
Note: For the automatic installer to function, the printer must be connected to an established
TCP/IP network.

Dynamic Methods of Setting the Printer's IP Address

There are two protocols available for dynamically setting the printer's IP address:
■ DHCP (enabled by default on all Phaser printers)
■ AutoIP
You can turn on/off both protocols using the control panel, or use CentreWare IS to turn on/off
DHCP.
Note: You can view the printer's IP address at any time. On the control panel, select
, press the OK button, select
Information
button.
Using the Control Panel
To turn on/off either the DHCP or AutoIP protocol:
1.
On the control panel, select
2. Select
Connection Setup
3.
Select Network Setup
4.
Select TCP/IP Setup
5. Select
DHCP/BOOTP
6. Press the OK button to turn the selection
Using CentreWare IS
To turn on/off the DHCP protocol:
1. Launch your web browser.
2. Enter the printer's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3. Select Properties.
4. Select the Protocols folder on the left navigation panel.
5. Select TCP/IP.
6. In the BOOTP/DHCP Settings section, set the BOOTP/DHCP option to On or Off.
7. Click the Save Changes button.
Printer Identification
Printer Setup , and then press the OK button.
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
or .
AutoIP
On
Phaser® 6360 Color Laser Printer
2-6
Configuring the Network Address
, and then press the OK
or Off .