Table of Contents
Advertisement
Since all bearings are sealed and permanently lubricated,
simply leave them alone until they need to be replaced.
Do not lubricate them.
This machine does need lubrication in other places. Do
not over-lubricate. Too much lubrication will attract dirt
and sawdust. Lubricate the following areas as needed to
maintain smooth function of the bandsaw.
Blade Guide Rack and Pinion
Multi-Purpose
As Needed
GL2 Grease
DISCONNECT BANDSAW FROM POWER!
Lower the blade guide until it reaches the table.
Using a rag and mineral spirits, wipe off any existing
grease and sawdust buildup on the rack (see
).
Apply a thin coat of multi-purpose GL2 grease to the
rack.
Move the blade guide up and down several times and
remove any excess grease to help prevent sawdust
buildup.
Tension Adjustment Assembly
Multi-Purpose
As Needed
GL2 Grease
DISCONNECT BANDSAW FROM POWER!
Open the top wheel cover and look through the top
of the wheel.
Using a rag and mineral spirits, wipe off any existing
grease and sawdust buildup on the blade tension
adjustment assembly and tension lever cam.
Apply a thin coat of multi-purpose GL2 grease to the
tension adjustment assembly and tension lever cam
(see
).
Thin Coat
Thin Coat
lubrication locations (top wheel removed
-46-
. Rack lubrication location.
Tension
Lever Cam
Tension
Adjustment
Assembly
Tension adjustment assembly
for clarity).
Advertisement
Table of Contents
