Table of Contents
Advertisement
DISCONNECT BANDSAW FROM POWER!
Adjust the blade tension until the mark on the blade
tension scale is between 4 and 6.
3. Loosen the table lock lever and the hex nut that
locks the positive stop bolt in place (see
4. Raise the guide post and place a machinist's square
on the table next to the side of the blade, as
illustrated in Figure
5. Use the table tilt handwheel to adjust the table
square with the blade, then secure it with the table
tilt lock lever (see
6. Adjust the positive stop bolt against the table and
secure it by tightening the hex nut against the
trunnion bracket.
Check the adjustment for accuracy once you have
tightened the hex nut.
8. Loosen the screw on the pointer, but do not remove
it.
9. Align the tip of the pointer with the 0˚ mark on the
table tilt scale.
10. Tighten the screw on the pointer so that the pointer
is locked in place.
.
on
).
-31-
).
Figure
. Table lock lever, positive stop
bolt and hex nut.
Figure
. Squaring table to blade.
Positive
Stop Bolt
Table
Lock Lever
Hex Nut
Advertisement
Table of Contents
