Restore Factory Default Settings; Resetting The Dp720 Handset; Resetting The Dp750 Base Station; Via Reset Button - Grandstream Networks DP720 Administration Manual

Hide thumbs Also See for DP720:

Table of Contents

RESTORE FACTORY DEFAULT SETTINGS

Warning:

Restoring the Factory Default Settings will delete all configuration information on the phone. Please

backup or print all the settings before you restore to the factory default settings. Grandstream is not

responsible for restoring lost parameters and cannot connect your device to your VoIP service provider.

Please follow the instructions below to reset the DP720 Handset:

1. Press "Menu" (left softkey) to bring up operation menu.

2. Press arrow keys to move the cursor to Settings and then press "Select".

3. Navigate to Registration, then press "Select "(left softkey).

4. Navigate to System Settings > Factory Reset, a warning window will pop out to make sure a

reset is requested and confirmed;

5. Press "Yes" (left softkey) to confirm and the phone will reboot.

To cancel the Reset, press "No" (right softkey) instead.

There are two methods to reset your base station to the default setting:

1. Locate the reset hole on the back panel of your DP750.

2. Insert a pin in this hole, and press for about 7 seconds.

3. Take out the pin. The unit will restart automatically with parameters restored to default values.

Via Web GUI

1. Access your DP750 base station web UI by entering its IP address in your favorite browser.

2. Enter your admin password (default: admin).

3. Press Login to access Maintenance > Factory Reset.

4. Press Reset button and the unit will prompt a confirmation message, press OK to reset the

handset, then the unit restart automatically with parameters restored to default values or press

Cancel to annul the reset.

DP750/DP720 Administration Guide

P a g e

Table of Contents

Dp750