QuiQue's Aircraft YAK-54 Assembly Manual page 41

3. CA thick foam to the masking
tape.
Figure 73
4. Attach a Sticky back Industrial
Velcro to the foam. I use
couple of drops of CA to make
sure that Velcro will not pull
free.
Figure 74
5. Use Sticky back Velcro with
CA on the plate.
Figure 75
6. Mount the battery on the
plate and wrap it with Velcro
straps. These batteries need
to be soft mounted. Having
foam underneath it and using
Velcro will ensure the safety
of your battery.
Figure 76
Figure 77
Ignition battery and switch
installation.
We recommend a Duralite digital
switch with built in regulator at 5.5v
that is extremely light.The following
steps are used to install this switch.
An alternative would be to use a 4.8v
NIMH battery and regular switch.
1. Mark the area that needs to
be cut on the fuse. Then use
an Xacto knife with sharp
blade to cut the fuselage.
41