Table of Contents
Advertisement
in the end of the pins to make sure
the front and rear pins are vertical as
this is very important
Step 4.
Let the epoxy harden. Stand the
wing on its wing tip and run some
thin C/A around the root rib. Wipe
away any excess. Do this several
times which will help to seal the pin
to the hole in the root rib.
Step 5
After the C/A has hardened, make a
fillet of 15 minute epoxy and micro
balloons and apply on the inside of
the root rib. I used a small length of
3/16" wooden dowel to apply the
epoxy-micro balloon mix.
Figure 12
Figure 13
Step 6
You will find some ¼" I.D. O-rings
and washers with the wing anti-
rotation package of parts. Use thin
C/A and glue the O-ring to the
washer. After you have installed the
wings to the fuse you will use this O-
ring and washer to slide over the
anti-rotation pin before you put the
keeper clip in the hole in the anti-
rotation pin.
Figure 14
Step 7
Now install the aileron servos the
way that output shaft is towards the
leading edge of the wing.
18
Hide quick links:
Advertisement
Table of Contents
