Table of Contents
Advertisement
is approximately 5 inches behind the
back of the landing gear.
Glue in the ply canister mount with
epoxy on both sides to the sides of
the fuse former.
After the epoxy hardens, add some
thick C/A along the bottom of the
canister mounting plate, as viewed
from the opening in the bottom of the
fuse and also along the opposite
side.
Figure 45
Figure 46
Figure 47
Figure 48
To avoid any contacts of silicone
tubing and cans,tie your tubing as in
Figure 49 below.
Figure 49
DA-100 and 3W 106 Throttle
Control Hook-up
Throttle tray is ready for you to install
your servo. Please see pics below.
31
Hide quick links:
Advertisement
Table of Contents
