Table of Contents
Advertisement
Required Tools and Adhesive
• Drill
• Thread lock
• Course sandpaper
• 5-minute epoxy
Step 1
Insert the three screws to attach the
tail wheel bracket.
Step 2
Attach the small piano wire control
steering arm and be sure to use
thread lock on all the screws. Make a
little double bend in the wire control
steering arm so it will fit in the rudder
steering point in the rudder. Use the
small ball link provided to insert into
the bottom of the rudder to accept
the steering arm wire.
Step 3
To attach the ball joint in the bottom
of the rudder, drill a hole with the
correct diameter and epoxy the ball
joint in place. For better adhesion,
rough up the shaft end of the ball
joint that is to be inserted into the
bottom of the rudder with course
sandpaper.
Section 6-Tail Wheel Installation
Figure 19
21
Hide quick links:
Advertisement
Table of Contents
