Toro 41568 Operator's Manual page 39

Important
Do not store stabilizer/conditioned
gasoline over 90 days.
11. Remove the spark plugs and check their condition; refer
to Changing Spark Plugs, page 35.
12. With the spark plugs removed from the engine, pour
two tablespoons of engine oil into the spark plug hole.
13. Use the electric starter to crank the engine and distribute
the oil inside the cylinder.
14. Install the spark plugs and tighten to recommended
torque; refer to Changing Spark Plugs, page 35.
Note: Do not install the wire on the spark plug(s).
15. Remove the battery from the chassis, check the
electrolyte level, and charge it fully; refer to Servicing
the Battery, page 36.
Note: Do not connect the battery cables to the battery posts
during storage.
Important The battery must be fully charged to prevent
it from freezing and being damaged at temperatures below
32 F (0 C). A fully charged battery maintains its charge for
about 50 days at temperatures lower than 40 F (4 C). If the
temperatures will be above 40 F (4 C), check the water
level in the battery and charge it every 30 days.
16. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
17. Check the condition of all spray hoses, replacing any
that are damaged or worn.
18. Tighten all hose fittings.
19. Paint all scratched or bare metal surfaces.
Paint is available from your Authorized Service Dealer.
20. Store the machine in a clean, dry garage or storage area.
21. Remove the ignition key and put it in a safe place out of
the reach of children.
22. Cover the machine to protect it and keep it clean.
39