Toro 41568 Operator's Manual page 16

2
Figure 12
1. Throttle lever
Ignition Switch
The ignition switch (Fig. 13), used to start and stop the
engine, has 3 positions: Stop, Run, and Start. Rotate the key
clockwise to the Start position to start the engine and
release it to the Run position when started. Rotate the key
to the Stop position to stop the engine.
3
2
Figure 13
1. Pressure gauge
2. Ignition switch
Pressure Gauge
The pressure gauge (Fig. 13) indicates the pressure of the
spray system. Refer to Pressure Gauge, page 20, for more
information.
Cruise Control Switch
The cruise control switch (Fig. 13) sets the forward speed
of the sprayer and holds it without pressure on the traction
pedal. Set the cruise control and maintain a speed as
follows:
1. Drive forward and attain the speed you desire; refer to
Driving the Sprayer, page 17.
2. Press the top of the cruise control switch.
The light on the switch illuminates.
1
2. Spray position
1
4
3. Cruise control switch
4. Headlight switch
16
3. Take your foot off of the traction pedal.
The sprayer will maintain the speed you set.
To release the cruise control, do one of the following:
Press the top of the cruise control switch.
Press the brake pedal.
The light on the switch turns off and the traction control
returns to the traction pedal.
Caution
If you press the switch to turn off the cruise
control and do not have your foot on the traction
pedal, the traction unit may come to a sudden stop
and cause you to lose control, possibly injuring you
or bystanders.
Ensure that you have you foot on the traction
pedal when you disengage the cruise control using
the switch.
Headlight Switch
Toggle the switch to operate the headlights (Fig. 13). Push
it forward to turn the lights on and rearward to turn them
off.
Hour Meter
The hour meter (Fig. 11) indicates the total number of
hours the engine has run. The hour meter starts to function
whenever the key is turned to the Run position.
1
Figure 14
1. Hour meter
2. Voltmeter
3. Engine oil pressure light
Voltmeter
The voltmeter (Fig. 14) indicates the level of charge in the
battery. When the battery is fully charged, the voltmeter
will read in the center of the dial when the key is in the Run
position with the engine off. When the engine is running
the voltmeter needle should be to the right.
2
3
4
4. Coolant temperature
gauge