Toro 41568 Operator's Manual page 27

Crankcase Capacity: w/filter, 3.5 qts (3.25 l)
Viscosity: Refer to the following table.
USE THESE SAE VISCOSITY OILS
–20 0 20
40
32
F
–30 –20 –10 0
C
1. Start the engine and let it run for five minutes. This
warms the oil so it drains better.
2. Set the parking brake, stop the pump, stop the engine,
and remove the ignition key.
3. Raise the seats.
Caution
Components under the seats will be hot if the
sprayer has been running. If you touch hot
components you may be burned.
Allow the sprayer to cool before performing
maintenance or touching components under the
hood.
4. Remove the access plug in the wall behind the engine
(Fig. 29).
1
Figure 29
1. Oil access plug
5. Place a pan below the oil drain.
6. Remove the drain plug (Fig. 30).
80 100
60
10 20 30 40
27
2
1
Figure 30
1. Oil drain plug
7. When the oil has drained completely, replace the drain
plug and torque it to 10 ft-lb (13.6 N m).
8. Remove the old oil filter (Fig. 30).
9. Wipe the filter adapter gasket surface.
10. Apply a thin coat of new oil to the rubber gasket on the
replacement filter.
11. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 1/2 turn (Fig. 30).
Important Do not over tighten the filter.
12. Dispose of the used oil and filter at a certified recycling
center.
13. Remove the oil filler cap and slowly pour
approximately 80% of the specified amount of oil into
the oil filler tube (Fig. 31).
2. Oil filter