Checking The Hydraulic Fluid - Toro 41568 Operator's Manual

The coolant should be 3/4 to 1-1/2 inches (2 to 4 cm)
below the bottom of the filler neck.
1
Figure 7
1. Radiator cap
3. If the coolant is low, add a solution of 50% water and
50% permanent ethylene glycol antifreeze.
Important Do not use water only or an
alcohol/methanol based coolant.
4. Install and secure the radiator cap.

Checking the Hydraulic Fluid

1. Position the sprayer on a level surface, set the parking
brake, stop the pump, stop the engine, and remove the
ignition key.
2. Clean the area around the hydraulic oil tank cap and
remove it (Fig. 8).
Important Be very careful not to get dirt or other
contaminants into the opening when checking the oil.
Figure 8
1. Hydraulic oil tank cap
3. Check the oil level by looking into the opening.
The oil should be 2 inches (5 cm) below the bottom of
the filler neck.
4. If the oil is low, fill the tank with Mobil 424
(Mobil 15M) hydraulic fluid or equivalent.
5. Install and secure the hydraulic oil tank cap.
Checking the Brakes
Before starting the sprayer, lightly press the brake pedal. If
the pedal travels more than 1 inch (2.5 cm) before you feel
resistance, adjust the brakes; refer to Adjusting the Brakes,
page 33.
If you operate the sprayer with poorly adjusted or
worn brakes you could lose control of the sprayer,
resulting in serious injury or death to you or
bystanders.
Always check the brakes before operating the
sprayer and keep them properly adjusted and
repaired.
Filling the Fresh Water Tank
The sprayer is equipped with a fresh water tank (Fig. 9) for
washing chemicals off of your skin, eyes, or other surfaces
in the case of accidental exposure. Always fill the fresh
water tank with clean water before handling or mixing any
chemicals.
2
1. Filler cap
2. Fresh water tank
To open the fresh water tank spigot, turn the lever on the
spigot toward the front of the sprayer.
14
Warning
1
2
3
Figure 9
3. Spigot