Toro 41568 Operator's Manual page 28

1
Figure 31
1. Oil filler cap
14. Check the oil level; refer to Checking the Engine Oil
Level, page 12.
15. Slowly add additional oil to bring the oil level to the
full mark on the dipstick.
Important
Overfilling the crankcase with oil may
cause engine damage.
16. Replace the oil filler cap and access plug.
Greasing the Sprayer
Lubricate all bearings and bushings after every
50 operating hours or once a year, whichever occurs first.
Grease Type: No. 2 General Purpose Lithium Base Grease
1. Wipe the grease fitting clean so that foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
The grease fitting locations are in the positions illustrated
in Figures 32 through 35.
Figure 32
One on the governor lever
Three inside each front wheel
One on each side of the centering arm, between the
tank and the engine compartment
28
Figure 33
Figure 34