Preparation (2)-①
Before using PTS, following modes must be selected.
(1) Selection of Transmission Mode ( Transmission Model is optional ).
There are 2 types of PTS models. Transmission model and non-transmission model.
If non-transmission model, either mode below may be selected.
① PRINTER MODE [ Prn ] ・・・・・・・Connect the printer ( option ) to out put the result on thermal paper.
② PC MODE
(2) Selection of [ Automotive ] Mode
[ Automotive ] and [ Industrial ] must be selected depending on usage.
application
Panel Display
Direction
Maximum Torque
Maximum Torque
for Loosening
How to Set
Loosening Mode
(3) On / Off of the abnormal fastening detection [ CH1 ] **
Select [ CH1 ] on or off.
◎ This function is for fastening wheel nuts.
It may detect [ CH1 ] even after fastening general bolts or nuts if the automotive [Aut] mode is selected.
** Please see page 17 for further information of [ CH1 ].
Initial Setting ( Description )
[ PC ] ・・・・・・・Connect a computer to transfer results
Automotive Mode
Aut
Right / Left handed screws
Up to the pre-set torque
selected currently
Up to the pre-set torque
selected currently
Press ④ of the display panel
[ - L - ] will be shown.
To continue loosening works,
please press ④ again.
( This loosening function only works
1 bolt/nut)
Industrial Mode
Ind
Right handed screws only
Up to the pre-set torque
selected currently
Up to 800 Nm
Turn the reverse lever to LEFT.
The Loosening Mode is automatically set.
(To turn the reverse lever, Fastening Mode
again)