Table of Contents
Advertisement
How to Fasten
Selecting the pre-set number ( for example, the pre-set number ① and 600Nm )
① Press the power switch. The display shows [ 0 ] blinking.
② Press ① for a few seconds. The pre-set ① is set 600 Nm.
When the display indicates ① [ P.1 ], release the key.
Soon after indicating [ P.1 ], the display also indicate
the torque value [ 600 ] Nm.
At this moment, the pre-set key ① is selected.
Selected pre-set key is valid until changing to other pre-set key.
③ Check the rotative direction ( Reverse Lever ).
R : Right Rotation
(Fastening the right
handed screw)
④ After placing the reaction force absorber next to the fastening bolt/nut, insert the socket to the fastening
bolt/nut and press the throttle lever.
( Caution )
・ In case of right handed screw, the reaction force absorber
rotates to the direction (A).
・ In case of left handed screw, direction (B)
The handle and the reactive force
absorber move synchronously.
Turn the handle and the reactive force
absorber to the workable direction with
the lock lever.
Industrial Mode [Ind]
Reverse
Reaction Force Absorber
How to operate the lock lever (example)
Turn the handle to the direction
of A while pressing the lock
lever. Then release the lock
lever and turn the handle to
the direction B.
The reactive force absorber
rotates to the direction C.
Lever
In case of fastening
the right handed
screw
Blinking
L : Left Rotation
(Fastening the
left handed screw
for [Aut] mode)
In case of fastening the
left handed screw.
( [Aut] mode only )
Lock Lever
Advertisement
Table of Contents
