KUKEN PTS-800ES Operation Manual page 11

How to Fasten
⑤ Press the throttle button to start
fastening.
Rotating the nut at the high speed
until the nut bottom out. When
bottoms out, the rotation speed
is switched to low to continue
the fastening.
⑥ Once reaches the pre-set torque, OK lamp will be
lit ( green ) and stops automatically.
The final attained torque blinks on the display panel.
*1 When reaching the set torque, the machine automatically stops and
rotates in the reverse direction at an ultra-low speed immediately to
prevent the socket bite. Immediately release your hand from the throttle
button when the counter-rotating starts.
⑦ If the throttle lever is released while operating,
NG lamp ( red ) will be lit to alert the operator.
When the throttle button is released or interrupted due to
finger slipping, make sure to re-fasten the nut.
Otherwise, check the set torque and the set mode.
Warning
・ While operating PTS, do not touch the reaction force absorber or the socket.
・ If something wrong with PTS, please release the throttle button and stop the
operation.
Industrial Mode [Ind]
How to insert the socket with the
throttle button ( slow start )
Pressing the throttle button
gently to rotate the spindle.
It is easier to insert the
socket when the spindle slowly
rotates.
*1
Press gently
While operating, the torque will
be shown in real time.
blinking
light up