Table of Contents
Advertisement
Troubleshooting (2)
● Error Code Description on PTS main unit ( troubles on the main unit )
Error Code
Panel Display
E01
E02
Lo
● Error Code Description on fastening
Error Code
Panel Display
If [ CH1 ] is turned on,
CH1
(CHECK1)
Result below pre-set torque
Under
Torque
● Error Code Description on loosening
Error Code
Panel Display
Description of Error Code
Causes
Malfunction of the torque sensor causes
the misalignment of ''zero point''.
The sensor detects the abnormal uprising
of the torque higher than the pre-set
torque.
Low batteries
Causes
Please see the next page [ Troubleshooting (3) ].
Releasing the throttle lever before reaching Please loosen the nut once and try
the pre-set torque.
(The figure shows 350Nm when releasing
the throttle lever).
Causes
[ when loosening mode is selected]
The loosening torque excesses the
maximum torque.
Measures
Please contact your dealer.
Please check the surface of screws
and grease and fasten again.
However [E02] is still shown on
the panel, please contact your
dealer.
Please replace with new batteries.
Measures
to fasten again.
Measures
Please loosen bolts/nuts with
an impact wrench.
Advertisement
Table of Contents
