Adjusting The Anti-Scalp Rollers; Adjusting The Flow-Baffle-Cam Locks - Toro 74946 Operator's Manual

Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the height
of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
1. Anti-scalp roller
2. Spacer
3. Bushing
1. Anti-scalp roller
2. Bushing
-
EUTRAL LOCK
Figure 27
4. Flange nut
5. Bolt
Figure 28
3. Flange nut
4. Bolt
Adjusting the Flow-Baffle-Cam
Locks
This procedure is applicable only to machines with flow-baffle
locks. Certain models have nuts and bolts in place of the
flow-baffle locks and can be adjusted the same.
position,
You can adjust the mower-discharge flow for different types
of mowing conditions. Position the cam locks and baffle to
achieve the best quality of cut.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. To adjust the cam locks, swing the lever up to loosen
the cam lock
4. Adjust the baffle and cam locks in the slots to the
desired discharge flow.
5. Swing the lever back over to tighten the baffle and cam
locks
6. If the cam locks do not lock the baffle into place or it
is too tight, loosen the lever and then rotate the cam
lock. Adjust the cam lock until you achieve the desired
locking pressure.
27
EUTRAL
(Figure 29).
(Figure 29).
Figure 29
- position,
LOCK