Ignition Switch - Toro 74946 Operator's Manual

Blade-Control Switch (PTO)
Use the blade-control switch (PTO) to engage the electric
clutch and drive the mower blades. Pull the switch up to
engage the blades and release. To disengage the blades,
push the blade-control switch (PTO) down or move a
motion-control lever into the N

Ignition Switch

This switch is used to start the mower engine and has 3
positions: Start, Run, and Off.
Motion-Control Levers
Use the motion-control levers to drive the machine forward
and reverse, and to turn either direction.
Neutral-Lock Position
Use the N - position with the safety-interlock
EUTRAL LOCK
system to engage and to determine the N
Fuel-Shutoff Valve
Close the fuel-shutoff valve (under the seat) when
transporting or storing the mower.
High-Oil Temperature Indicator Light
This is the malfunction-indicator light found on the left side
(Figure 5).
If the engine-oil temperature rises above the safe level, the
light illuminates, the engine automatically reduces the rpm,
and the machine remains in a safe mode until the corrective
action is taken; refer to Troubleshooting (page
- position.
EUTRAL LOCK
position.
EUTRAL
70).
Low-Oil Pressure Indicator Light
This is the middle malfunction-indicator light
If the engine-oil pressure drops below a safe level, this light
illuminates, the engine automatically reduces the rpm, and the
machine remains in a safe mode until the corrective action is
taken; refer to Troubleshooting (page
Electronic Control Unit Malfunction
Indicator Light
The electronic control unit (ECU) continuously monitors the
operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction indicator light (MIL) illuminates.
The MIL is the red light located in the right console panel.
Once the MIL illuminates, make initial troubleshooting
checks. Refer to the MIL section under
(page 70).
If these checks do not correct the problem, further diagnosis
and servicing by an Authorized Service Dealer is necessary.
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
15
(Figure 5).
70).
Troubleshooting