Servicing The Fuses - Toro 74946 Operator's Manual

Installing the Battery
1. Position the battery in the tray with the terminal posts
opposite from the hydraulic tank
2. Install the positive (red) battery cable to the positive
(+) battery terminal.
3. Install the negative (black) battery cable and ground
wire to the negative (-) battery terminal.
4. Secure the cables with 2 bolts, 2 washers, and 2 locknuts
(Figure 57).
5. Slide the red terminal boot onto the positive (+) battery
terminal.
6. Install the clamp and secure it with the wing nut
57).
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important: Always keep the battery fully charged
(1.265 specific gravity). This is especially important to
prevent battery damage when the temperature is below
0°C (32°F).
1. Charge battery for 10 to 15 minutes at 25 to 30 A or
for 30 minutes at 10 A.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
3. Install the battery in the machine and connect the
battery cables; refer to
Note: Do not run the machine with the battery
disconnected; electrical damage may occur.
(Figure 57).
(Figure
(Figure 58).
Installing the Battery (page
1. Positive battery post
2. Negative battery post

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
1. The fuses are located on right hand console next to
the seat (Figure
2. To replace the fuses, pull out on the fuse to remove it.
3. Install a new fuse
46).
1. Optional accesory—15A
2. Charge—25A
3. PTO—10A
46
Figure 58
3. Red (+) charger lead
4. Black (-) charger lead
59).
(Figure 59).
Figure 59
4. Main—25A
5. Console