Toro 74946 Operator's Manual page 26

Figure 25
Transport-Lock Positions
1. Transport lock
2. L position—The
OCK
mower deck locks into the
transport position.
3. U position—The
NLOCK
mower deck does not lock
into the transport position.
Adjusting the Height-of-Cut Pin
Adjust the height-of-cut from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1. Move the transport lock to the L
2. Push on the deck-lift pedal with your foot and raise
the mower deck to the Transport position (also the
140 mm or 5-1/2 inch cutting-height position) as
shown in Figure
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired, and insert the pin
26).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
1. Deck-lift pedal
2. Height-of-cut pin
26
position.
OCK
26.
(Figure 26).
Figure 26
3. Transport lock
(Figure