Table of Contents
Advertisement
Adjusting the Height-of-Cut
The height-of-cut can be adjusted from 38 to 127 mm
(1-1/2 to 5 inches) in 6 mm (1/4 inch) increments.
Note:
Using a height-of-cut under 51 mm (2 inches)
increases the wear on the mower-deck belt. Use a
height-of-cut that is greater than 51 mm (2 inches)
whenever possible.
Figure 20
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers.
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the nut and bolt position the anti-scalp
rollers and install the nut and bolt.
4.
Ensure that the spacers and bushings are
installed
(Figure
1. Bushing
2. Anti-scalp roller
3. Spacer
Adjusting the Flow Baffle
You can adjust the mower-discharge flow for different
types of mowing conditions. Position the cam lock
and baffle to provide the best quality of cut.
1.
Disengage the PTO, move the motion-control
g267253
levers to the N
engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
To adjust the baffle, loosen the knob
4.
Adjust the baffle and knob in the slot to the
desired discharge flow and tighten the knob.
21
EUTRAL
21).
Figure 21
4. Bolt
5. Nut
-
position, and
EUTRAL
LOCK
(Figure
-
LOCK
g018324
22).
Advertisement
Table of Contents
