Cleaning The Hydraulic Units - Toro 74946 Operator's Manual

2
1
4
Figure 73
1. Oil filter
2. Left side bolts for the
cooling-fan housing
7. Remove the cooling-fan housing.
8. Using compressed air, blow out any debris and grass
from the engine parts, particularly around the cylinder
head cooling fins and ignition coils.
9. Install all the shrouds onto the engine.
3
2
4
g016907
3. Battery
4. Right side bolts for the
cooling-fan housing

Cleaning the Hydraulic Units

Service Interval: Before each use or daily
1. Disengage the blade-control switch (PTO) and set the
parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Move the seat forward.
4. Clean the debris and grass from the hydraulic units
(Figure 74).
5. Position the seat.
1. Hydraulic units
53
Figure 74