Table of Contents
Advertisement
When using this product, always follow the basic safety precautions to reduce the
!
risk of fire, electric shock and injury to persons, including the following:
Always install the product as described in the documentation that is included
with your product.
Avoid using this product during an electrical storm. There may be a remote
risk of electric shock from lightning.
Do not use this product to report a gas leak in the vicinity of the leak.
Directive
Unless express and prior approval by Technicolor in writing, you may not:
Disassemble, de-compile, reverse engineer, trace or otherwise analyse the equipment,
its content, operation, or functionality,
or otherwise attempt to derive source code (or the underlying ideas, algorithms,
structure or organization) from the equipment,
or from any other information provided by Technicolor, except to the extent that this
restriction is expressly prohibited by local law;
Copy, rent, loan, re-sell, sub-license, or otherwise transfer or distribute the equipment
to others;
Modify, adapt or create a derivative work of the equipment;
Remove from any copies of the equipment any product identification, copyright or
other notices;
Disseminate performance information or analysis (including, without limitation,
benchmarks) from any source relating to the equipment.
Such acts not expressly approved by Technicolor will result in the loss of product warranty
and may invalidate the user's authority to operate this equipment in accordance with FCC
Rules.
Technicolor disclaims all responsibility in the event of use that does not comply with the
present instructions.
Safety instructions
Climatic conditions
This product:
Is intended for in-house stationary desktop use; the maximum ambient temperature
may not exceed 40°C (104°F).
Must not be mounted in a location exposed to direct or excessive solar and/or heat
radiation.
Must not be exposed to heat trap conditions and must not be subjected to water or
condensation. Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
Must be installed in a Pollution Degree 2 environment (Environment where there is no
pollution or only dry, nonconductive pollution).
Cleaning
Unplug this product from the wall socket and computer before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning.
Water and moisture
Do not use this product near water, for example near a bathtub, washbowl, kitchen sink,
laundry tub, in a wet basement or near a swimming pool. Transition of the product from a
cold environment to a hot one may cause condensation on some of its internal parts. Allow
it to dry by itself before re-starting the product.
Secure handling and disposal of used batteries
NOTE: Only use the battery qualified for this equipment.
Remember to dispose batteries properly according to local regulation, i.e. at a battery
collection point. Batteries may not be disposed with domestic waste.
Interface classifications
The external interfaces of the product are classified as follows:
Phone: TNV circuit, not subjected to over voltages (TNV-2)
Cable, MoCA, RF: TNV circuit subject to overvoltages (TNV-1)
All other interface ports (e.g. Ethernet, USB, etc.), including the low voltage power
input from the AC mains power supply: SELV circuits.
Electrical powering
The powering of the product must adhere to the power specifications indicated on the
marking labels.
USB
The device is to be connected to an identified USB port complying with the requirements
of a Limited Power Source.
Accessibility
The plug on the power supply cord serves as disconnect device. Be sure that the power
socket outlet you plug the power cord into is easily accessible and located as close to the
equipment as possible.
Overloading
Do not overload mains supply socket outlets and extension cords as this increases the risk
of fire or electric shock.
Servicing
To reduce the risk of electric shock, do not disassemble this product. None of its internal
parts are user-replaceable; therefore, there is no reason to access the interior. Opening or
removing covers may expose you to dangerous voltages. Incorrect reassembly could cause
electric shock if the appliance is subsequently used.
If service or repair work is required, take it to a qualified service dealer.
Damage requiring service
Unplug this product from the wall outlet and refer servicing to qualified service personnel
under the following conditions:
When the power supply or its plug are damaged.
When the attached cords are damaged or frayed.
If liquid has been spilled into the product.
If the product has been exposed to rain or water.
If the product does not operate normally.
If the product has been dropped or damaged in any way.
There are noticeable signs of overheating.
If the product exhibits a distinct change in performance.
Immediately disconnect the product if you notice it giving off a smell of burning or smoke.
Under no circumstances must you open the equipment yourself; you run the risk of
electrocution.
Regulatory information
You must install and use this device in strict accordance with the manufacturer's instructions
as described in the user documentation that is included with your product.
Before you start installation or use of this product, carefully read the contents of this
document for device specific constraints or rules that may apply in the country where you
want to use this product.
In some situations or environments, the use of wireless devices may be restricted by the
proprietor of the building or responsible representatives of the organization.
If you are uncertain of the policy that applies on the use of wireless equipment in a specific
organization or environment (e.g. airports), you are encouraged to ask for authorization to
use this device prior to turning on the equipment.
Technicolor is not responsible for any radio or television interference caused by
unauthorized modification of the device, or the substitution or attachment of connecting
cables and equipment other than specified by Technicolor. The correction of interference
caused by such unauthorized modification, substitution or attachment will be the
responsibility of the user.
Technicolor and its authorized resellers or distributors are not liable for any damage or
violation of government regulations that may arise from failing to comply with these
guidelines.
North-America - United States of America
Important safety instructions
The cable distribution system should be grounded (earthed) in accordance with ANSI/
NFPA 70, the National Electrical Code (NEC), in particular Section 820,93,
Grounding of outer Conductive Shield of a Coaxial Cable.
Leave 5 to 8 cm (2 to 3 inches) around the product to ensure proper ventilation to it.
Never push objects through the openings in this product.
Federal Communications Commission (FCC) radio frequency interference statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1
This device may not cause harmful interference, and
2
This device must accept any interference received, including
interference that may cause undesired operation.
RF-exposure statement
When the product is equipped with a wireless interface, then it becomes a mobile or fixed
mounted modular transmitter and must have a separation distance of at least 20 cm (8
inches) between the antenna and the body of the user or nearby persons. In practice, this
means that the user or nearby persons must have a distance of at least 20 cm (8 inches)
from the modem and must not lean on the modem in case it is wall-mounted.
With a separation distance of 20 cm (8 inches) or more, the M(aximum) P(ermissible)
E(xposure) limits are well above the potential this module is capable to produce.
For operation within 5.15 ~ 5.25GHz frequency range, it is restricted to indoor environment.
This device meets all the other requirements specified in Part 15E, Section 15.407 of the
FCC Rules.
This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
Restricted frequency band
This product is equipped with an IEEE802.11b/IEEE802.11g/IEEE802.11n wireless
transceiver and may only use channels 1 to 11 (2412 to 2462 MHz) on U.S.A. territory.
Hide quick links:
Advertisement
Table of Contents
