Table of Contents
Advertisement
INSTALLATION
• Install the appliance away from heat sources. Installation in a hot
environment, direct exposure to the sun or installation near heat
sources (heaters, radiators, cookers) will increase power
consumption and should therefore be avoided.
• If this is not possible, the following minimum distances must be
respected:
• 30 cm from coal or paraffin stoves;
• 3 cm from electric and/or gas stoves.
• Fit the spacers on the rear of the condenser at the back of the
appliance (see figure).
• To optimize appliance efficiency, leave a 5 cm gap above the
appliance and make sure that adjacent kitchen units are
sufficiently distanced to allow air circulation.
• Install the appliance in a dry, well-ventilated place, and ensure it
is level, using the front adjustment feet if necessary.
• Clean the interior.
• Fit the accessories.
Electrical Connection
• Electrical connections must be made in accordance with local regulations.
• Voltage and power consumption are indicated on the rating plate inside the appliance.
• Regulations require that the appliance is earthed.
The manufacturer declines all liability for injury to persons or animals and for damage to
property resulting from failure to observe the above procedures and reminders.
• If the plug and socket are not of the same type, have the socket replaced by a qualified electrician.
• Do not use extension leads or adapters.
Disconnecting the appliance
It must be possible to disconnect the appliance by unplugging it or by means of a two-pole switch fitted
upline of the socket.
16
Advertisement
Table of Contents
