Installation Instructions; Location Requirements; Electrical Requirements; Unpack The Wine Cellar - Whirlpool WWC287BLS - Wine Cooler Use And Care Manual

Use and care manual
Hide thumbs Also See for WWC287BLS - Wine Cooler:
Table of Contents

Advertisement

Available languages

Available languages

Location Requirements

WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from wine cellar.
Failure to do so can result in death, explosion, or fire.
To ensure proper ventilation for your wine cellar, allow for a 5"
(127 mm) space between the back of the beverage center and
the wall. When installing your beverage center next to a fixed
wall, leave 13 " (33.7 cm) minimum clearance on the hinge side
to allow for the door to swing open.
NOTE:
It is recommended that you do not install the wine cellar
near an oven, radiator, or other heat source. Do not install
in a location where the temperature will fall below 55°F
(13°C). For best performance, do not install the wine
cellar behind a cabinet door.
It is recommended that you install the wine cellar in a
location that allows the door to have a greater than 45°
opening. A limited door swing will keep the shelves from
sliding out as intended and may lead to damaging the
door gasket.
The rough cabinet opening must be on a level floor and at
least 24" (60 cm) deep and 12 " (31.75 cm) wide.
5" (12.17 cm)
4

INSTALLATION INSTRUCTIONS

13 " (33.66 cm)

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your wine cellar into its final location, it is
important to make sure you have the proper electrical
connection.
Recommended grounding method
A 115 Volt, 60 Hz., AC only, 15– or 20–amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your wine cellar be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation or cleaning
unplug wine cellar or disconnect power.

Unpack the Wine Cellar

WARNING
Excessive Weight Hazard
Use two or more people to move and install wine cellar.
Failure to do so can result in back or other injury.
Remove the Packaging
Remove tape and glue residue from surfaces before turning
on the wine cellar. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your wine cellar. For
more information, see "Wine Cellar Safety."
Dispose of/recycle all packaging materials.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WWC287BLS - Wine Cooler and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents