Whirlpool ARC 1800 Instruction Manual

Built in wine cooler


Quick Links

ARC 1800
Built in Wine Cooler Instruction Manual


Table of Contents

Summary of Contents for Whirlpool ARC 1800

  • Page 1 ARC 1800 Built in Wine Cooler Instruction Manual...
  • Page 2: Important Safety Information

    A. IMPORTANT SAFETY INFORMATION The appliance which you have purchased is a wine cooler – a professional appliance intended exclusively for keeping wines. This manual contains important information regarding safety, the use and maintenance of your appliance. Read the manual and keep it in an easily accessible place for future consultation.
  • Page 3 • Locate the wine cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly. Operate the wine cooler in ambient temperatures specified by its temperature class marked on the rating plate.
  • Page 4 REMEMBER WHEN ARRANGING Place the bottles in a central position on the rack. When closing the door make sure that the bottles do not touch the glass door. Highly concentrated alcohol must be kept hermetically closed and in a vertical position.
  • Page 5: Control Panel

    B. OPERATING INSTRUCTIONS CONTROL PANEL Indicator light illuminates to signify the cooling mode is currently in operation Light To turn on/ off the inner light Power To switch on/ off the appliance (press and hold for approximately 3 seconds) Set Upper To set the temperature of the upper chamber Set Lower To set the temperature of the lower chamber...
  • Page 6: Removing Shelves

    REMOVING SHELVES Attention: To prevent damaging the door gasket, make sure to have the door all the way opened when pulling shelves out of the rail compartment. For easy access to the storage content, you must pull the shelves approximately 1/3 out of the rail compartment, however this unit was designed with a notch on each sides of the shelf tracks to prevent bottles from falling.
  • Page 7 1. Screws 2. Top hinge (right) 3. Lock hole decorative cover 4. Decorative nails 5. Screws 6. Door axis (right) 7. Door bracket 8. Lower hinge (left) 9. Lower hinge (right) 10. Top hinge (left) 1. Take out the 4 screws (1) from the top hinge (right) (2) and remove the top hinge (right), then remove the door.
  • Page 8: Installation Precaution

    C. INSTALLATION INSTALLATION PRECAUTION • Place the wine cooler on a floor that is strong enough to support it when it is fully loaded. To level your wine cooler, adjust the front leveling leg at the bottom of the wine cooler. •...
  • Page 9: Care And Maintenance

    D. CARE & MAINTENANCE CLEANING OF THE WINE COOLER Switch off the power, unplug the appliance and remove all items including shelves and rack. Wash the inside surfaces with warm water and mild solution. Wash the shelves with mild detergent solution. Wipe excess water with a sponge or cloth when cleaning area of the control or any electrical parts.
  • Page 10: Troubleshooting Guide

    E. TROUBLESHOOTING GUIDE Problem Possible Cause Wine Cooler does not ‐ The plug is not plugged into the socket properly. operate ‐ The appliance is switched off. ‐ There is a power cut. Wine Cooler is not cold ‐ Temperature control setting is not set properly. enough ‐...

Table of Contents