Model 07273/Tc; Safety And Instructional Decals - Toro 07266 Operator's Manual

Measured values were determined according to the
procedures outlined in EN 1032.
Whole Body Vibration
Measured vibration level = 0.42 m/s
Uncertainty Value (K) = 0.5 m/s
Measured values were determined according to the
procedures outlined in EN 1032.

Model 07273/TC

Sound Pressure
This unit has a guaranteed sound power level of 96 dBA,
which includes an Uncertainty Value (K) of 1 dBA.
Sound power level was determined according to the
procedures outlined in EN ISO 11094.

Safety and Instructional Decals

Safety decals and instructions are easily visible to the operator and are located near any area of
potential danger. Replace any decal that is damaged or lost.
1. Warning—read the Operator's Manual.
2. Collision hazard—do not operate the vehicle on public streets,
roads, or highways.
3. Falling hazard—do not carry passengers in the cargo bed.
4. Falling hazard—do not allow children to operate the vehicle.
5. To start the engine, sit on the operator's seat, release the
parking brake, turn the power key on, pull the choke lever out
(if needed), and press the accelerator pedal.
6. To stop the engine, release the accelerator pedal, set the
parking brake, turn the power key off, and remove the power
key.
2
2
117–5001
Sound Pressure
This unit has a sound pressure level at the operator's
ear of 81 dBA, which includes an Uncertainty Value (K)
of 1 dBA.
Sound pressure level was determined according to the
procedures outlined in EN ISO 11201.
Hand-Arm Vibration
Measured vibration level for right hand = 1.5 m/s
Measured vibration level for left hand = 1.03 m/s
Uncertainty Value (K) = 0.5 m/s2
Measured values were determined according to the
procedures outlined in EN 1032.
Whole Body Vibration
Measured vibration level = 0.42 m/s
Uncertainty Value (K) = 0.5 m/s
Measured values were determined according to the
procedures outlined in EN 1032.
7. Horn
8. Hour meter
9. Headlights
10. Power—Off
11. Power—On
12. Electrical power (power point)
8
2
2
2
2