Servicing The Battery - Toro 07266 Operator's Manual

CAUTION
Any surface contamination can damage the
headlight bulb and leading to its failure or explosion
creating a serious safety hazard.
Head light lamps should be handled without
touching the clear quartz, either by using a clean
paper towel or carefully holding the base.
Specification: See your Parts Catalog.
1. Disconnect the electrical harness from the bulb
housing on the back of the lamp.
2. Remove the bulb assembly by turning it 1/4 turn
counter clockwise and moving it rearward, out of the
lamp housing.
3. Remove the bulb from the base taking care not to
touch the halogen quartz.
4. Install a new bulb on the base. Use a paper towel
to grasp the new bulb with handling it to avoid
contaminating the surface.
5. Insert the new bulb and assembly into the headlight
housing and secure by turning it 1/4 turn clockwise
to lock it in place.
6. Connect the electrical harness.
Replacing the Headlight
When removing or replacing the headlight assembly,
disconnect the wiring harness to the bulb assembly if the
bulb is to be removed with the lamp.
1. Remove the speed clips and washers securing the
headlight in place. Retain all parts.
2. Remove the headlight assembly by moving it forward
through the opening in the front bumper (Figure 34).
2
1
6
5
Figure 34
1. Headlight
2. Opening in front end
3. Headlight bulb assembly
G009198
3
4
4. Headlight bulb harness
connection
5. Speed clip
6. Flat washer
3. Install the new headlight through the opening in the
bumper (Figure 34). Ensure the adjustment posts
are lined up with the holes in the mounting bracket
in the bumper.
4. Secure the headlight assembly with the washers and
speed clips removed previously.
5. Attach the headlight to the wire harness removed
previously.
6. Adjust the headlights to direct the beams to the
desired position.
Adjusting the Headlights
Use the following procedure to adjust the headlight
beam position whenever a headlight assembly is replaced
or removed.
1. Turn the ignition key to the On position and turn on
the headlights.
2. At the headlight assembly, use the fasteners to pivot
the headlight assembly and affect the cast beam
position.

Servicing the Battery

CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Important: Do not jump start the vehicle.
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery and battery box. If
the battery terminals are corroded, clean them with a
solution of four parts water and one part baking soda.
Apply a light coating of grease to the battery terminals
to prevent corrosion.
Voltage: 12 volt with 280 cold cranking Amps @ 0
degrees F (-18 degrees C).
Removing the Battery
1. Position the vehicle on a level surface, set the parking
brake, turn the ignition off, and remove the key.
2. Locate the battery on the right side of the machine,
behind the passenger seat. Remove the battery cover.
30
WARNING