Fuel System Maintenance; Inspecting Fuel Lines And Connections; Replacing The Fuel Filter; Electrical System Maintenance - Toro 07266 Operator's Manual

Table of Contents

Advertisement

Fuel System
Maintenance
Inspecting Fuel Lines and
Connections
Service Interval: Every 400 hours
Check the fuel lines and connections every 400 operating
hours or yearly, whichever occurs first. Inspect them for
deterioration, damage, or loose connections.

Replacing the Fuel Filter

Service Interval: Every 800 hours
Replace the fuel filter every 800 operating hours or
yearly, whichever occurs first.
1. Raise the box and support it with the prop rod.
2. Place a clean container under the fuel filter.
3. Remove the clamps securing the fuel filter to the fuel
lines (Figure 32).
Figure 32
1. Fuel filter
4. Install the replacement filter to the fuel lines with the
clamps previously removed.
Mount the filter so that the arrow points toward the
carburetor.
Electrical System
Maintenance

Replacing the Fuses

There are 3 fuses in the electrical system. They are
located beneath the dash on the driver's side (Figure 33).
Auxillary (Open)
Ignition System/Horn
Headlights
Power Point
1. Fuse block
2. Ground block

Replacing the Headlights

Before performing any maintenance set the parking
brake, turn the ignition off, and remove the key.
Release the retaining straps on the hood and raise the
hood to access the headlights.
Replacing the Bulbs
CAUTION
The halogen bulbs become extremely hot when in
operation. Handling a hot bulb can cause severe
burns and personal injury.
Always all enough time to for the bulbs to cool
before replacing them. Use care whenever handling
the bulb.
29
Figure 33
3. Pedal assembly
30 A
10 A
15 A
20 A

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

07266tc0727307273tc07279Workman mdWorkman mdx

Table of Contents