Datavideo AD-100M Quick Start Manual page 10

set of speakers it should not be used like an Audio AMP.
•
Press the MENU button to enter the system configuration settings.
•
Turn the ADJUST Knob to select the RESET ALL setting.
•
The cursor will flash at the beginning of this menu option.
•
Press MENU button again to move the flashing cursor to the setting
position.
•
Turn the ADJUST knob to change the RESET ALL setting from NO to YES.
•
Press the ADJUST knob in for 2 seconds, the system will return to the
factory defaults.
•
The setting will return to NO.
•
Press the MENU or MODE button to start to review the units default
settings.
Factory Default Settings
AUDIO_DELAY
DELAY_TIME
ATTENUATION
TONE_OUT
TONE_MODE
TONE_LEVEL
8. SOFTWARE VERSION
•
Press the MENU button to enter the system configuration settings.
•
Turn the ADJUST knob to select SOFTWARE VERSION.
•
The firmware version of the AD-100M is displayed for 12 seconds.
9. ESCAPE
•
After reviewing or changing the system configuration settings.
•
Turn the ADJUST knob to select ESCAPE.
•
Press the ADJUST knob in to exit the system configuration settings
mode.
•
Alternatively press the MODE button to exit the system configuration
settings instantly.
OFF
10ms
-0dB
OFF
1KHz
+4dBu
10