Table of Contents
Advertisement
Before using this unit
Setting the Voltage selector
(Worldwide models only)
Worldwide models are equipped with a voltage selector to conform
with local power supplies. Be sure to set this switch to match the
voltage of the power supply in your area before plugging in the unit.
Determine the proper voltage for your area: 220-230 V or 120 V.
If the preset voltage is not correct for your area, insert a screwdriver
into the groove in the switch. Slide the switch all the way to the upper
(120 V) or to the lower (220-230 V), whichever is appropriate.
COMPONENT VIDEO
ANTENNA
Y
P
B
P
R
Y
P
B
P
R
Y
P
B
P
R
AM
OUTPUT
INPUT 1
INPUT 2
IN
OUT
IN
OUT
IN
IN
IN
VIDEO
FM
MONITOR
DVD
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
75
OUT
REMOTE
CONTROL
S VIDEO
PHONO
CD
TAPE
OUT
IN
L
L
R
R
FRONT
SURR
CENTER
OPTICAL
COAXIAL
L
1
2
1
GND
2
R
SUB
SUBWOOFER
WOOFER
MULTI
PRE OUT
CHANNEL INPUT
DIGITAL INPUT
Installing the remote controller batteries
1. Remove the battery compartment cover by pressing
and sliding the cover.
2. Insert two AA (R6 or UM-3) batteries into the battery
compartment. Carefully follow the polarity diagram
(positive (+) and negative (–) symbols) inside the
battery compartment.
3. After batteries are installed and seated correctly,
replace the compartment cover.
1
2
Notes:
• Do not mix new batteries with old batteries or different kinds of
batteries.
• To avoid corrosion, remove the batteries if the remote controller
is not to be used for a long time.
• Remove dead batteries immediately to avoid damage from
corrosion. If the remote controller does not operate smoothly,
replace both the batteries at the same time.
• The life of the batteries supplied is about six months but this will
vary depending on usage.
FRONT
CENTER
SURROUND
SPEAKERS
SPEAKER
SPEAKERS
R
L
L
R
AC OUTLET
SWITCHED
100W MAX.
AV RECEIVER
VOLTAGE
ZONE 2
:
TX-DS696
MODEL NO. /
SPEAKERS
SELECTOR
VOLTAGE
SELECTOR
R
R
L
L
PRE OUT
CAUTION:
120V
FRONT
SURR
CENTER
SEE INSTRUCTION MANUAL
FOR CORRECT SETTING.
L
1
220-230V
6 OHMS
4 OHMS
MIN.
MIN.
/ SPEAKER
/ SPEAKER
R
2
120V
SET BEFORE POWER ON
IMPEDANCE SELECTOR
220-230V
3
Using the remote controller
Point the remote controller toward the remote control sensor. The
STANDBY indicator lights up when the unit receives a signal from
the remote controller.
Remote control sensor
STANDBY indicator
30˚
Notes:
• Place the unit away from strong light such as direct sunlight or
inverted fluorescent light which can prevent proper operation of
the remote controller.
• Using another remote controller of the same type in the same
room or using the unit near equipment which uses infrared rays
may cause operational interference.
• Do not put objects on the remote controller. Its buttons may be
pressed by mistake and drain the batteries.
• Make sure the audio rack doors do not have colored glass.
Placing the unit behind such doors may prevent proper remote
controller operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
TX-DS696
30˚
Approx. 5 meters
(16 feet)
7
Hide quick links:
Advertisement
Table of Contents
