Before Using This Unit; Setting The Voltage Selector (Worldwide Models Only); Installing The Remote Controller Batteries; Using The Remote Controller - Onkyo TX-SR800 Instruction Manual

Before using this unit

Setting the voltage selector
(Worldwide models only)
Worldwide models are equipped with a voltage selector so that you
can set your TX-SR800 to conform with local power supplies. Be
sure to set this switch to match the voltage of the power supply in
your area before plugging in the unit.
Determine the proper voltage for your area: 220-230 V or 120 V. If
the preset voltage is not correct for your area, insert a screwdriver
into the groove in the switch and slide the switch all the way to the
top (120 V) or bottom (220-230 V), whichever is appropriate.
DIGITAL PRE OUT COMPONENT
AUDIO VIDEO S VIDEO
INPUT
R L ANTENNA VIDEO
COAX FRONT OUTPUT
MONITOR
OUT
1 Y
SUB CENTER
2 AM OUT ZONE 2 P
B
R L
SURR
3 IN DVD P R
SURR
R L
BACK/
OPT INPUT 1
ZONE 2
FM
1 OUT Y
75
VIDEO 1
FRONT
MULTI CH
2 INPUT IN P B
AUDIO
R L
R L
SUB CENTER
3 PHONO OUT P
R
VIDEO 2
INPUT 2
SURR
CD IN Y
DIGITAL
OUTPUT
R L
OUT
OPT IN VIDEO 3 P B
SURR
BACK
TAPE
VIDEO 4
IN P R
IN
GND
R L R L
AUDIO AUDIO VIDEO S VIDEO

Installing the remote controller batteries

1. Remove the battery compartment cover by pressing it
and sliding it in the direction shown by the arrow
below.
2. Insert two AA (R6 or UM-3) batteries into the battery
compartment. Carefully follow the polarity diagram
(positive (+) and negative (–) symbols) inside the
battery compartment.
3. After the batteries are installed and seated correctly,
replace the compartment cover.
1 2
Notes:
• Do not mix new batteries with old batteries or different kinds of
batteries.
• To avoid corrosion, remove the batteries if the remote controller
will not be used for a long time.
• Remove dead batteries immediately to avoid damage from
corrosion. If the remote controller does not operate smoothly,
remove the old batteries and replace them both with two new AA
batteries.
FRONT SPEAKERS SURR SPEAKERS
R L R L
CAUTION:
SPEAKER
AC OUTLETS
IMPEDANCE
SWITCHED
4 OHMS MIN. OR TOTAL 100W MAX.
6 OHMS MIN.
/SPEAKER
SEE
INSTRUCTION
MANUAL FOR
CORRECT
SETTINGS.
VOLTAGE
SELECTOR
VOLTAGE
R SURR BACK/ L
SELECTOR
CENTER SPEAKER ZONE 2 SPEAKERS
120V
I R
AV RECEIVER
IN
TX-SR 800
MODEL NO.
220-230V
REMOTE
CONTROL
OUT
120V
220-230V
3

Using the remote controller

Point the remote controller toward the remote control sensor. The
STANDBY indicator lights up when the unit receives a signal from
the remote controller.
Remote control sensor
STANDBY indicator
30˚
30˚
SEND/LEARN indicator
Notes:
• Make sure that the remote control sensor is not subject to strong
light such as direct sunlight or inverted fluorescent light for it
may prevent proper operation of the remote controller.
• Using another remote controller in the same room or using the
TX-SR800 near equipment that uses infrared rays may cause
operational interference.
• Do not put objects on the remote controller. Its buttons may be
pressed by mistake and drain the batteries.
• Make sure the audio rack doors do not have colored glass.
Placing the TX-SR800 behind such doors may prevent proper
remote controller operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
TX-SR800
Approx. 16 feet
(5 meters)
7