Care And Cleaning - KKT KOLBE FLAT INSEL ED User Manual

Care and cleaning

. Care and cleaning
Prior to any maintenance or cleaning
work, isolate the hood from the electrical
supply by
pulling out the appliance connector plug
or tripping the house installation circuit
breaker or fully unscrew the screw type
fuse from the house installation
• The extractor hood is not to be clea-
ned with a steam cleaner.
• Do not use cleaning agents containing
alcohol to clean appliances with a
matt black inish. These can lead to
discolouring.
• Non-compliance with the mainte-
nance and cleaning instructions can
result in a ire hazard due to grease
deposits.
• The grease ilters on your appliance
are to be cleaned or replaced at regu-
lar intervals.
• 'ilters saturated with grease can
quickly catch ire and also distribute
unpleasant odours.
• Grease ilters obstructed by dirt par-
ticles seriously impair the appliance
function.
• When cleaning the area of the control
elements, take great care to prevent
water entering the electronics.
Gewerbliches inhaltliches Kopieren verboten! Gewerbliches inhaltliches Kopieren verboten!
Special information for appliances
with a stainless steel casing
A commercially available non-abrasive
stainless steel cleaning agent should be
used for cleaning stainless steel surfaces.
Treatment with a stainless steel preser-
vative is recommended to prevent sur-
faces becoming quickly re-soiled. Apply
the agent all over and economically
using a sot cloth.
!
Never use stainless steel cleaning
agents in the vicinity of the control
elements.
When cleaning metal grease ilters take
care not to damage the mesh. 'requent
cleaning or the use of aggressive cleaning
agents can cause colour changes to the
metal surface. These do not afect the
ilter function and are not grounds for
complaint.
. Changing the grease ilter
• Change paper grease ilters monthly.
• Change paper grease ilters with
alarm everytwo months or when the
colour of the surface becomes visible
through the mesh openings. This ilter
is coloured on one side; ater itting,
this colouring must not be visible
through the mesh openings.