Changing The Lamps - KKT KOLBE FLAT INSEL ED User Manual

Care and cleaning
• Foam grease ilters must be soaked
once a month in warm soapy water for
to hours. Do not wring out; repeat
where required and replace the ilter
by a new item ater a maximum of -
washes.
• Metal grease ilters do not have to be
replaced when they are over-satura-
ted but washed once a month by hand
or in a dishwasher
ilter to dry thoroughly and carefully
replace it in the extractor hood.
!
Avoid using alkaline dishwasher
cleaning agents ph value over .
. Carbon ilters
a Traditional carbon ilters normally
round in shape can be neither washer
nor regenerated. In normal use and de-
pending on their size, replace every to
months. Comply with the relevant ins-
tructions on the package.
b Washable and regeneratable carbon
ilters normally square in shape are
to be washed once a month in a dish-
washer, using a standard rinsing agent
and with the intensive rinsing program
at the highest temperature . Washable
and regeneratable carbon ilters absorb
kitchen odours for a maximum of years
when cleaned monthly. The ilter should
then be replaced by a new item.
!
Washable and regeneratable carbon il-
ters should be washed separately to avo-
id food residue deposits which can later
Gewerbliches inhaltliches Kopieren verboten! Gewerbliches inhaltliches Kopieren verboten!
° . Allow the
cause unpleasant odours. Ater washing,
the washable and regeneratable carbon
ilter must be reactivated. This is carried
out by drying the cleaned ilter in an oven
for minutes at
Read the package to see whether your
carbon ilter is washable and regenera-
table.
If the package carries no information,
then it contains a traditional, non-was-
hable carbon ilter.
'ach time you change or wash a grea-
se ilter or carbon ilter, ater removal
clean all exposed lower parts of the hood
with a mild grease solvent. 'or the daily
cleaning of the outer pats of the hood use
a sot cloth moistened with alcohol or a
mild liquid cleaner. Never use an abrasi-
ve cleaner.
There is a risk of ire if the instructions
for cleaning the hood and the changing
or cleaning of the ilters are not complied
with.

. Changing the lamps

!
When changing a lamp, make sure that
the new lamp does not have a higher
wattage than that of the original.
Disconnect before changing the lamps
your power supply. The lamp can be
changed directly.
°C.