Subscribe to Our Youtube Channel
Related Manuals for KKT KOLBE DRAFT900
Summary of Contents for KKT KOLBE DRAFT900
- Page 1 User’s manual for your down-draft cooker hood Model: DRAFT900 Version: 1.2 / 160422...
- Page 2 Hints and symbols Dispose of the dishwasher packaging material correctly. All packaging materials can be recycled. Plastic parts are marked with the standard international abbreviations: (e.g. PS for polystyrene, padding material) This appliance is identified according to the European guideline 2002/96/EC on waste electrical and electronic equipment -WEEE.
- Page 3 Safety informations • Keep children away from the unit. The operation of the device by child- ren is permitted only under adult supervision. • The device is designed for household operation and is to be used exclu- sively for that. •...
- Page 4 For installation, please read the installation section. Read all the safety instructions carefully before use and keep this Instruction / Installation Manual for future reference. User’s guide Down-Draft cooker hood DRAFT900 Version 1.0 © 2014 KKT KOLBE Küchentechnik. KKT KOLBE is a registred trademark.
-
Page 5: Table Of Contents
Table of content Overview 1. General notes 1.1 Intended use 1.2 Protection of the environment 1.3 Tips and general advice 2. Before using the hood 3. Using the hood 3.1 Operating safety information 3.2 In exhaust air mode 3.3 In circulation air mode 4. -
Page 6: General Notes
General notes 1. General notes 1.2 Protection of the environment 1.1 Intended use 1.2.1 Package The packing materials are 100% recyc- lable. Comply with local regulations for their disposal. The appliance is intended for domestic use. The manufacturer is not responsible for damage resulting from improper use or maloperation. -
Page 7: Before Using The Hood
General notes 2. Before using the hood of the heater or other non-electric opera- ted appliances. c) No flambé dishes are to be prepared under the extractor hood. The open flames could destroy the hood or even cause a kitchen fire. Ensure that the hood has not suffered d) Never leave pans unwatched when damage during transport. -
Page 8: In Exhaust Air Mode
Safety 3.3 In circulation air mode The inlet air is filtered through a carbon • Due to the fire risk, frying or cooking filter (also known as active carbon filter) with oils and fats under the hood is and circulated in the room. The carbon only to take place under constant filter captures the odours produced surveillance. -
Page 9: Care And Cleaning
Care and cleaning 4. Care and cleaning Special information for appliances with a stainless steel casing Prior to any maintenance or cleaning A commercially available non-abrasive work, isolate the hood from the electrical stainless steel cleaning agent should be supply by: used for cleaning stainless steel surfaces. -
Page 10: Carbon Filters
Care and cleaning ble and regeneratable carbon filter must be • Foam grease filters must be soaked reactivated. This is carried out by drying the once a month in warm soapy water for cleaned filter in an oven for 10 minutes at 1 to 2 hours. -
Page 11: What To Do If
Fault – what to do if... 6. Fault – what to do if ... When the lightning fails: Motor problems • Does the lamp need changing? • Is there a power supply failure? • Has the lamp been properly fitted and •... -
Page 12: Installation
Installation 7. Installation 7.1 Installation data / dimensions On installation, the minimum distance between the hob and the hood must be exactly complied with (see chapter 7.1 “Installation data“) and follow the num- bering of the steps and the additional instructions. -
Page 13: Using The Extractor Hood As An Exhaust Air Hood
Installation Only connect the appliance to the power Never install the appliance if the data supply once it is properly installed. on the rating plate does not agree with your supply voltage. 7.2 Using the extractor hood as You will find the rating plate inside the an exhaust air hood (with air appliance, behind the grease filter. -
Page 14: Appliance Components
Control panel Content: A: Light on/off B: Decrease power C: Digital display D: Increase E: Button to lift the hood up Lift up/down: Adjust the hood power: If you press the extract button E for 2 Use the buttons B and D to reduce or in- seconds, the hood begins to lift up and crease the power level. -
Page 15: Troubleshooting
Installation 10. Troubleshooting Problem Possible causes Solution Light on, but motor does not Air flap jammed Rectify jamming Faulty capacitor Change capacitor Motor bearing faulty Change motor Suspicious smell from Change motor motor Light not on, motor does not The following are possible in addition to the above causes Faulty lamps... -
Page 16: Informations On Air Flow
Installation of the hood 11. Exhaust air pipeline be a large temperature drop within the individual parts of the pipeline, resulting in sweating or condensation water production. This renders outlet pipeline insulation necessary. • In some cases a condensation water barrier must be installed in addition to adequate insulation 1: Air outlet to outdoors... -
Page 17: General Installation Instruction
Installation of the hood 12. Before installation 1 Clean the area thoroughly before installation, so that at the first time, no dust or debris can be aspirated. 2 The exhaust hose must not be routed together with gas pipes, hot-air pipes, etc. - Page 18 Installation of the hood ✓ Please get an exhaust duct 150 mm with ✓ Provide the worktop with the matching two hose clamps (not included!) cutouts for the ventilation system. ✓ Provide the countertop with a cutout for ✓ Insert the ventilation system in the cut-out the cooktop.
- Page 19 Installation of the hood...
- Page 20 Installation of the hood ✓ Mounting the motor unit: ✓ You have the option to connect the motor unit to the right or left on the vent housing ✓ Alternatively, you can run the engine as an external fan. (Note: Required Accessories are not included) ✓...
Need help?
Do you have a question about the DRAFT900 and is the answer not in the manual?
Questions and answers