Setting up the base
The following diagram is an overview of tall the connections for your base.
connections are described in detail below. In order to make calls over VoIP you must connect the
base to the Internet and register at least one handset to the base.
Follow the steps in the order given below:
Follow the steps in the order given below:
1. Connect the power cable to the base.
2. Connect the base to the mains power supply.
3. Connect the base to the router/ switch to access the Internet and configure the base via the
Web configurator (Internet connection via router and moden or via router with integrated
modem).
4. Connect the PC to the router.
NB. The Gigaset N510 IP PRO is supplied with sufficeint power via PoE (Power over Ethernet) if
the device is connected to an Ethernet switch with PoE functionality (PoE class IEEE802.3af). In
this case it is not necessary to tconneccdt the device to the mains power supply and steps 1 and 2
should be omitted.
Configuration Manual
7
(for VOIspeed 6)
The individual