Recording Paper Cover, Panel Rear Cover, Control Panel And Microphone - Brother FAX-170 Service Manual

1.5

Recording Paper Cover, Panel Rear Cover, Control Panel and Microphone*

(1) Place the control panel ASSY upside down.
(2) Turn the panel lock arm until the cutout provided in it becomes aligned with the boss of
the arm support, then pull it out to the left.
(3) Remove the two screws "a" from the recording paper cover and lift up the rear edge of
the cover.
(4) Remove the ADF parts (ADF film, separator and leaf spring), using the spring hook and
a flat screwdriver. Once removed, they will become unusable and new parts should
have to be put back in.
(5) Remove the four screws "b" from the panel rear cover, then unhook the latch "L" and lift
up the cover.
(6) For the FAX-270MC/290MC/520DT/520MC/MFC370MC/390MC: Remove the two
screws "c" from the control panel PCB.
Unlock the LCD cable connector and disconnect the LCD flat cable to take out the
control panel PCB and the FPC key.
(7) To separate the FPC key from the control panel PCB, unlock the FPC key connector
and disconnect the FPC key.
Panel lock arm
ADF parts
Main-panel harness
Latch "L"
Recording
paper cover
Arm support
"a"
ADF film
Separator
Leaf spring
"b"
"a"
"b"
"b"
"b" Panel rear cover
"c"
"c"
FPC key
FPC key connector
Control panel PCB
LCD flat cable
LCD
IV – 11
LCD cable connector
Microphone*
Control panel
* Provided on the FAX-270MC/
290MC/520DT/520MC/
MFC370MC/390MC.