Brother FAX-170 Service Manual page 116

Selector
No.
1
Automatic cutter
CCITT superfine recommendation
2
3 Remote reception
4
Not used.
5
6
Exclusive line mode
7
Max. document length limitation
8
Not used.
Selector 1: Automatic cutter
The selector activates or deactivates the automatic cutter.
Selector 2: CCITT superfine recommendation
If this selector is set to "1," the equipment communicates in CCITT recommended superfine
mode (15.4 lines/mm). If it is set to "0," it communicates in native superfine mode.
Selector 3: Remote reception
Setting this selector to "0" allows the facsimile equipment to receive data from the directly
connected external telephone only. Setting it to "1" allows the equipment to receive data
from all telephones sharing a modular wall socket with the equipment, as well as from the
directly connected external telephone.
If any of the following problems occurs frequently, set this selector to "0":
• Dialing from any of the telephones sharing a modular wall socket starts the facsimile
equipment.
• Picking up the handset for any telephones sharing a modular wall socket while the equip-
ment is in receiving operation disrupts the received image due to the superimposed
noise.
Selector 6: Exclusive line mode
Setting this selector to "1" connects the equipment to the exclusive line, which enables trans-
mission merely by pressing the Start key without dialing operation at both the calling and
called terminals.
Selector 7: Max. document length limitation
This selector is used to select the maximum length of a document to be sent.
WSW16
(Function setting 1)
Function
V – 28
Setting and Specifications
0: ON 1: OFF
0: OFF 1: ON
0: Only from the 1: From all
connected
external
telephone
0: OFF 1: ON
0: 400 cm 1: 90 cm
telephones
connected