Bottom Plate - Brother FAX-170 Service Manual

1.17 Bottom Plate

(1) Place the main frame upside down.
(2) Remove the four screws.
(3) Slightly lift up the bottom plate and disconnect the grounding terminal.
Grounding terminal
Resin PCB support "b"
Reassembling Notes
• Before putting the bottom plate back into place, make sure that the power supply PCB is
completely fitted in the resin PCB supports without any gap.
After installing the bottom plate, check that resin PCB support "b" of the main frame ap-
pears from the checking hole "a" provided in the bottom plate and that the bottom plate is
fitted in the main frame without any gap.
If the power supply PCB comes into contact with the bottom plate, a short circuit may oc-
cur.
Checking hole "a"
(Front)
Main frame
(placed upside down)
IV – 28
Bottom plate