Common Procedures In Setup Menu; Speaker Setup - Onkyo HT-RC160 Instruction Manual

Advanced Setup—Continued

Common Procedures in Setup Menu

ENTER
SETUP

Speaker Setup

Some of the settings in this section are set automatically by the Audyssey 2EQ™ Room Correction and Speaker Setup
function (see page 45).
Here you can check the settings made by the Audyssey 2EQ Room Correction and Speaker Setup function, or set them
manually, which is useful if you change one of the connected speakers after using the Audyssey 2EQ Room Correction
and Speaker Setup function.
Note:
The Speaker Setup cannot be carried out while headphones are connected to the AV receiver.
Speaker Settings
See "Speaker Settings" on page 42.
Speaker Configuration
With these settings, you can specify which speakers are connected and a crossover frequency for each speaker. Specify
"Full Band" for speakers that can output low frequency bass sounds adequately, for example, speakers with a good
sized woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover frequency will be
output by the subwoofer instead of the speaker. Refer to your speaker's manuals to determine the optimum crossover
frequencies.
Subwoofer
*1
Front
*2
Center
*2
Surround
*2*3*5*6
Front High
*3*4*5*7
Surr Back
*8
Surr Back CH
RECEIVER
qwer
Yes: Select if a subwoofer is connected (default).
No: Select if no subwoofer is connected.
Full Band, 40Hz to 100Hz (default), 120Hz, 150Hz, 200Hz
Full Band, 40Hz to 100Hz, 120Hz, 150Hz, 200Hz
None: Select if no speaker is connected.
1ch: Select if only one surround back L speaker is connected.
2ch: Select if two (left and right) surround back speakers are connected (default).
1
Press the [RECEIVER] button followed by
the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn't appear, make sure the
appropriate external input is selected on your TV.
2
Use the Up and Down [q]/[w] buttons to
select main menu, and then press
[ENTER].
3
Use the Up and Down [q]/[w] buttons to
select the function, and then press
[ENTER].
4 Use the Up and Down [q]/[w] buttons to
select setting, and then use the Left and
Right [e]/[r] buttons to set them.
5
When you've finished, press the [SETUP]
button.
The setup menu closes.
67