Table of Contents
Advertisement
Drive System
Maintenance
Adjusting the Traction-Pedal
Angle
1. Loosen the 2 nuts and bolts securing the left side of the
traction pedal to the bracket
Figure 60
1. Traction pedal
2. Pivot the pedal to the desired operating angle and
tighten the nuts
(Figure
Checking the
Planetary-Gear-Drive Oil
Service Interval: Every 400 hours (check if you notice
external leakage).
Every 400 hours
Use high quality SAE 85W-140 gear lube as a replacement.
1. With machine on level surface, position the wheel so 1
check plug is at the 12 o'clock position and the other
is at 3 o'clock position
Figure 61
1. Check/drain plug (2)
2. Remove the plug at the 3 o'clock position
(Figure
60).
2. Mounting nuts and bolts
60)˙.
(Figure
61).
g019500
(Figure
Note: The oil level should be at the bottom of the
check-plug hole.
3. If the oil level is low, remove the plug at the 12 o'clock
position and add oil until it begins to flow out of the
hole at the 3 o'clock position.
4. Install both plugs.
Changing the
Planetary-Gear-Drive Oil
Service Interval: After the first 200 hours
Every 800 hours/Yearly (whichever comes first)
1. With the machine on a level surface, position a wheel
so a check plug is at the lowest (6 o'clock) position
(Figure
62).
1. Check/drain plug
2. Place a drain pan under the planetary hub, remove the
plug, and allow the oil to drain.
3. Place a drain pan under the brake housing, remove the
drain plug, and allow the oil to drain
1. Drain plug
4. When all of the oil has drained from both locations,
install the plug in the brake housing.
5. Rotate the wheel until the open plug hole in the
planetary is at the 12 o'clock position.
61).
52
Figure 62
(Figure
g020680
Figure 63
2. Brake housing
63).
Advertisement
Table of Contents
