Table of Contents
Advertisement
Important: Use only the hydraulic fluids
specified. Other fluids could cause system
damage.
Figure 76
1. Hydraulic reservoir
5. Install the reservoir cap, start the engine, and use all
of the hydraulic controls to distribute hydraulic fluid
throughout the system.
6. Check for leaks; then shut off the engine.
7. Check the fluid level and add enough to raise level the
level to the Full mark on the dipstick.
Note: Do not overfill.
Replacing the Hydraulic Filters
Service Interval: After the first 200 hours
Every 800 hours
Use Toro replacement filters Part No. 94-2621 for the rear
(mower deck) of the machine and Part No. 75-1310 for the
front (charge) of the machine.
Important: Use of any other filter may void the warranty
on some components.
1. Position the machine on a level surface, lower the
mower decks, shut off the engine, engage the parking
brakes, and remove the ignition key.
2. Replace the hydraulic filters
3. Start the engine and let it run for about 2 minutes to
purge air from the system and shut off the engine and
check for leaks.
Checking the Hydraulic Lines
and Hoses
Service Interval: Every 2 years
Inspect the hydraulic lines and hoses daily for leaks, kinked
lines, loose mounting supports, wear, loose fittings, weather
deterioration, and chemical deterioration. Make all necessary
repairs before operating the machine.
60
(Figure
77).
Figure 77
Advertisement
Table of Contents
