Replacing The Mower-Deck-Hinge Covers - Toro 30643 Operator's Manual

Figure 85
1. Caster wheel
2. Caster-pivot arm
2. Remove the bearing from the wheel hub and allow the
bearing spacer to fall out
3. Remove the bearing from the opposite side of the
wheel hub.
4. Check the bearings, spacer, and inside of the wheel hub
for wear and replace any damaged parts.
5. To assemble the caster wheel, push the bearing into
the wheel hub.
Note: When installing the bearings, press on the outer
face of the bearing.
6. Slide the bearing spacer into the wheel hub and push
the other bearing into the open end of the wheel hub
to captivate the bearing spacer inside the wheel hub.
7. Install the caster-wheel assembly between the caster
fork and secure it in place with the bolt and locknut.
Replacing the
Mower-Deck-Hinge Covers
The hinge cover prevents debris from escaping at hinge points
between mower decks. If the cover(s) become damaged or
worn, replace them.
3. Bearing
4. Bearing spacer
(Figure 84 and Figure 85).
64
Figure 86