Table of Contents
Advertisement
Figure 20
4. Push the caster spindle through the front caster arm.
5. Install the shims (as they were originally installed) and
the remaining spacers onto the spindle shaft.
6. Remove the hairpin cotter and clevis pins from the
caster-pivot arms
(Figure
7. Rotate the tension rod to raise or lower the pivot
arm until the holes are aligned with the selected
height-of-cut bracket holes in the mower-deck frame
(Figure 21
and
Figure
Figure 21
1. Caster-pivot arm
2. Axle-mounting holes
Figure 22
8. Insert the clevis pins and install the hairpin cotters.
9. Rotate the tension rod counterclockwise (finger tight)
to put tension on adjustment.
21).
22).
3. Clevis pin and hairpin
cotter
4. Tension rod
Adjusting the Skids
Mount the skids in the lower position when operating at
heights of cut greater than 64 mm (2-1/2 inches) and in the
higher position when operating at heights of cut lower than
64 mm (2-1/2 inches).
Adjusting the Mower-Deck
Rollers
The mower-deck rollers should be mounted in the lower
position when operating at height-of-cuts greater than 64 mm
(2-1/2 inches) and in the higher position when operating in
height-of-cuts lower than 64 mm (2-1/2 inches).
27
Figure 23
Figure 24
Advertisement
Table of Contents
