Using Zone 2/3 - Onkyo TX-NR1008 Instruction Manual

To use the same volume level as when the AV receiver was
last turned off, select "Last".
The "Zone2 Power On Volume" and "Zone3 Power On
Volume" cannot be set higher than the "Zone2 Maximum
Volume" and "Zone3 Maximum Volume" setting.

Using Zone 2/3

This section explains how to turn Zone 2/3 on and off,
how to select an input source for Zone 2/3, and how to
adjust the volume for Zone 2/3.
Controlling Zone 2/3 from the AV receiver
ZONE 3 indicator
ZONE 2 indicator
ZONE 3
OFF
ZONE 2
1
To turn on Zone 2/3 and select an input source,
press ZONE 2 or ZONE 3 followed by an input
selector button within 8 seconds.
Zone 2/3 turns on, the ZONE 2/3 indicator lights.
Tip
• ZONE 2/3 12V TRIGGER OUT goes high (+12 V).
To select AM or FM, press TUNER input selector
and ZONE 2 or ZONE 3 repeatedly.
(North American models) You can also select SIR-
IUS.
To select the same source as that of the main room,
press ZONE 2 or ZONE 3 twice. "Zone 2 Selector:
Source" or "Zone 3 Selector: Source" appears on
the display.
2
To turn off Zone 2/3, press ZONE 2 or ZONE 3.
ZONE 2 or ZONE 3 indicator flashes.
Press OFF.
The zone is turned off, and the ZONE 2 or ZONE 3
indicator goes off.
Note
• When Zone 2/3 is turned off, the output from the ZONE 2/3
12V TRIGGER OUT goes low (0 volts).
En
76
Input selector buttons
Controlling Zone 2/3 with the Remote
Controller
STANDBY
ON
INPUT
SELECTOR
Note
• To control Zone 2/3, you must press the remote controller's
ZONE first.
• ZONE turns red while Zone 2 is on, and green while Zone 3 is
on.
1
Press ZONE repeatedly, then point the remote
controller at the AV receiver and press ON.
Tip
• The ZONE 2/3 12V TRIGGER OUT goes high (+12 V).
2
To select an input source for Zone 2/3, press
ZONE repeatedly, followed by INPUT SELEC-
TOR.
To select AM or FM, press TUNER input selector
and ZONE repeatedly.
(North American models) You can also select SIR-
IUS.
3
To turn off Zone 2/3, press ZONE repeatedly, fol-
lowed by STANDBY.
Note
• Only analog input sources are output by the ZONE 2/3 PRE
OUT and FRONT WIDE/ZONE 2 L/R, FRONT HIGH/ZONE
3 L/R terminals. Digital input sources are not output. If no sound
is heard when an input source is selected, check if it's connected
to an analog input.
• You cannot select different AM or FM radio stations for your
main room and Zone 2/3. The same AM/FM radio station will be
heard in each room. For example, if you have an FM station for
the main room, that station will also be used in Zone 2.
• When you connect ZONE3 speakers directly to the AV receiver,
Dolby Pro Logic IIz Height listening mode that require front
high speakers is unavailable.
• When the input selector of Zone 2/3 is selected, power consump-
tion on standby mode slightly increases.
• While Zone 2/3 is on, u functions will not work.
ZONE