Onkyo TX-NR1008 Instruction Manual page 14

• Don't connect more than one cable to each speaker terminal. Doing so may damage the AV receiver.
• Don't connect one speaker to several terminals.
Connecting the Speaker Cables
Screw-type speaker terminals
Strip 1/2" to 5/8" (12 to 15 mm) of
insulation from the ends of the
speaker cables, and twist the bare
wires tightly, as shown.
Using Banana Plugs (North American models)
• If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.
• Do not insert the speaker code directly into the center hole of the speaker terminal.
The following illustration shows which speaker should be connected to each pair of terminals. If you're using only one
surround back speaker, connect it to the SURR BACK L terminals.
Front high
right
speaker
Surround
right
speaker
En
14
1/2" to 5/8"(12 to 15 mm)
Front wide
right Front right
speaker speaker
Surround
back right
speaker
Front wide
Front left left
speaker speaker
Surround
back left
speaker
Front high
left Center
speaker speaker
Surround
left
speaker