Learning Commands - Onkyo TX-NR1008 Instruction Manual

6
Press ENTER.
A message for transfer will appear.
Now we are ready to transfer data to the remote.
Please hold the remote so that it is facing the receiver.
Use ENTER button of your remote to activate "OK".
Ready?
OK
To use the remote controller, point it at the AV
receiver's remote control sensor, as shown below.
Remote control sensor (Transmitter)
Incoming sensor
7
Press ENTER.
When the transfer is successful, the following screen
appears.
Return
8
Press ENTER.
The "Activities Setup" menu appears onscreen.
9
Press SETUP.
The setup menu closes.
En
90
8–2. Activities Setup
My Movie
15
15
Approx.
15° off center
16ft. (5 m)
(Left/Right/Up/Down)
8–2. Activities Setup
My Movie
Wait...
8–2. Activities Setup
My Movie
Successful

Learning Commands

The AV receiver's remote controller can learn the com-
mands of other remote controllers. By transmitting, for
example, the Play command from your CD player's
remote controller, the remote controller can learn it, and
then transmit the exact same command when its 1 is
pressed in the CD remote mode.
This is useful when you've entered the appropriate remote
86) but some buttons don't work as
control code (➔
expected.
ON
REMOTE
MODE
1
While holding down REMOTE MODE for the
mode in which you want to use the command,
press and hold down ON until REMOTE MODE
button lights (about 3 seconds).
2
On the supplied remote controller, press the but-
ton you want to learn the new command.
3
Point the remote controllers at each other, about 2
to 6 inches (5 to 15 cm) apart, and then press and
hold the button whose command you want to learn
until REMOTE MODE button flashes.
If the command is learned successfully, REMOTE
MODE button flashes twice.
About 2 to 6
inches (5 to 15 cm)
Supplied remote
controller
4
To learn more commands, repeat steps 2 and 3.
Press any REMOTE MODE when you've finished.
REMOTE MODE button flashes twice.