Onkyo TX-NR1008 Instruction Manual page 46

■
BD/DVD, VCR/DVR, CBL/SAT, GAME, PC, AUX,
TV/CD, PHONO, PORT
IN 1, IN 2:
Select a corresponding component video input that
the video component has been connected.
- - - - -:
Select if you are using HDMI output, rather than the
COMPONENT VIDEO MONITOR OUT, for the
output from composite video, S-Video, and compo-
nent video sources.
Note
• For composite video and S-Video upconversion for the COM-
PONENT VIDEO MONITOR OUT, the "Monitor Out" set-
ting must be set to "Analog"
Video Input" setting must be set to "- - - - -". See "Video Con-
nection Formats" for more information on video signal flow and
upconversion (➔ 22).
• If not connected to the same output you have selected in the
"Monitor Out" setting, the "Monitor Out" setting will be auto-
matically switched to "Analog"
• If you connect a component (such as UP-A1 Dock that seated
iPod) to the UNIVERSAL PORT jack, you cannot assign any
input to "PORT" selector.
Digital Audio Input
If you connect a component to a digital audio input, you
must assign that input to an input selector. For example, if
you connect your CD player to the OPTICAL IN 1, you
must assign "OPT 1" to the "TV/CD" input selector.
Here are the default assignments.
Input selector
BD/DVD
VCR/DVR
CBL/SAT
GAME
PC
AUX
TUNER
TV/CD
PHONO
PORT
En
46
43), and the "Component
(➔
(➔ 43).
Default assignment
COAX 1
COAX 2
COAX 3
OPT 1
- - - - -
FRONT (Fixed)
- - - - - (Fixed)
OPT 2
- - - - -
- - - - -
■
BD/DVD, VCR/DVR, CBL/SAT, GAME, PC,
TV/CD, PHONO, PORT
COAX 1, COAX 2, COAX 3, OPT 1, OPT 2:
Select a corresponding digital audio input that the
component has been connected.
- - - - -:
Select if the component is connected to an analog
audio input.
• "AUX" is used only for input from the front panel.
Note
• When an HDMI IN is assigned to an input selector in "HDMI
45), the same HDMI IN will be set as a priority in this
Input" (➔
assignment. In this case, if you want to use the coaxial or optical
audio input, make the selection in the "Audio Selector" in the
Home menu (➔ 62).
• Available sampling rate for PCM signals from a digital input
(optical and coaxial) is 32/44.1/48/88.2/96 kHz/16, 20, 24 bit.
• If you connect a component (such as UP-A1 Dock that seated
iPod) to the UNIVERSAL PORT jack, you cannot assign any
input to "PORT" selector.
Analog Audio Input
Some DVD players output the LFE channel from their
analog subwoofer output at 15 dB higher than normal.
With this setting, you can change the AV receiver's sub-
woofer sensitivity to match your DVD player.
■
Subwoofer Input Sensitivity
0dB to 15dB in 5 dB step.
Note
• This setting only affects signals connected to the AV receiver's
multichannel input SUBWOOFER jack.
• If you find that your subwoofer is too loud, try the 10 dB or
15 dB setting.