Resetting Remote Mode Buttons; Resetting The Remote Controller; Controlling Other Components - Onkyo TX-NR1008 Instruction Manual

Onkyo av receiver user manual
Hide thumbs Also See for TX-NR1008:
Table of Contents

Advertisement

Resetting REMOTE MODE Buttons

You can reset a REMOTE MODE to its default remote
control code.
1
While holding down REMOTE MODE that you
want to reset, press and hold down HOME until
REMOTE MODE button lights (about 3 seconds).
2
Within 30 seconds, press REMOTE MODE again.
REMOTE MODE button flashes twice, indicating
that the button has been reset.
Each of REMOTE MODE is preprogrammed with a
remote control code. When a button is reset, its pre-
programmed code is restored.
Note
The learning command is also reset.

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
While holding down RECEIVER, press and hold
down HOME until RECEIVER lights (about 3 sec-
onds).
2
Within 30 seconds, press RECEIVER again.
RECEIVER flashes twice, indicating that the
remote controller has been reset.

Controlling Other Components

By pressing REMOTE MODE that's been programmed
with the remote control code for your component, you can
control your component as below.
For details on entering a remote control code for other
components, see "Entering Remote Control Codes"
(➔
86).
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the p
some models). The TV must be able to receive remote
control commands via p and be connected to the
AV receiver via HDMI. If controlling your TV via
p doesn't work very well, program your TV's
remote control code into TV and use the TV remote mode
to control your TV.
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player or DVD Recorder
BD/DVD is preprogrammed with the remote control code
for controlling a component that supports the p
(limited to some models). The component must be able to
receive remote control commands via p and be
connected to the AV receiver via HDMI.
*1
The
p
supported by the
system control function of the HDMI standard.
*1
(limited to
*1
is the CEC
AV receiver
En
87

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents